Comment on page
DOWNLOAD
SYNC
Make sure you installed the Driver for USB before continuing the next steps.
1/ Before upgrade:
– Download the latest Software version for MAC or Windows if not install yet.
– Install USB Driver if not installed yet.
– Download the Firmware in Zip format.
– Unzip to get the *.hex file.
– Unplug Remote Receiver (SBUS, JR, …) if it was plugged to gStabi system.
– Connect Gimbal to you Mac or PC by USB cable.
2/ During upgrade:
– Power on Gimbal.
– Run the software and select Upgrade.
– Follow Steps on the screen.
3/ Troubleshooting
If you have failed during the firmware upgrade, please follow this article to configure again
You can also contact our support via [email protected] for prompt support

