This section allows you to configure video streaming parameters for optimal performance based on your network conditions and operational requirements.
Determines whether the stream starts automatically when the system powers on:
Enable – Automatically initiates video streaming
Disable – Requires manual start.
Sets the data rate for video transmission. Higher bitrates offer better quality but require more bandwidth:
512 Kbps
1 Mbps
2 Mbps
4 Mbps
8 Mbps
Defines the stream endpoint name used by RTSP clients (e.g., VLC, Payload Assitant App/Desktop):
Default: payload
You can change this value as needed for your streaming setup.
Specifies the port number used for RTSP streaming:
Default: 8554
📌 Ensure this port is open and not blocked by firewalls on your network.
Select the desired output resolution:
1920 × 1080 (Full HD)
1280 × 720 (HD)
640 × 360 (Low Bandwidth Mode)
Choose the video compression format:
H.264 (AVC) – Standard and widely supported
H.265 (HEVC) – Higher efficiency, reduced bandwidth usage
Set the number of video frames per second (FPS):
Range: 1 to 30 FPS
Lower frame rates reduce bandwidth and power consumption.
Enable or disable a separate infrared video stream:
Enable – Streams IR video independently from EO
Disable – IR is not streamed or is embedded with EO feed
Click “APPLY” to save and apply your selected streaming configuration. Streaming changes may take effect immediately or require a system reboot.
Last updated
Was this helpful?
Was this helpful?
