GREMSY PRODUCT SUPPORT

GREMSY
Payloads
GENERAL
- UPGRADE FIRMWARE & SOFTWARE
  - GIMBAL FIRMWARE
    7.7.3 Upgrade Note
    How to Autotune?
- QUICK RELEASE
Gremsy Damping
- Rubber Specification
- Damping Plate Specification
Tiny Gimbal
- G-Hadron
PIXY & MIO
SERIES GREMSY T & S
Heavy Gimbal
- AEVO
PE
- GREMSY T3PE
GREMSY H SERIES
OPTIONAL MODULE

Powered by GitBook

On this page

Option 1: Auto Upgrade
Option 2: Manual upgrade

GIMBAL FIRMWARE

G-Hadron Diagram for product integration

PreviousUPGRADE FIRMWARE & SOFTWARE Next7.7.3 Upgrade Note

Last updated 1 year ago

Option 1: Auto Upgrade

Step 1: Before the upgrade

Download the latest Software version for MAC or Windows if not installed yet.
Unplug the Remote Receiver (SBUS, JR, …) if it was plugged into the gStabi system.
Power on the gimbal.
Connect Gimbal to your Mac or PC by USB cable.

Step 2: Upgrade firmware

Run the gTune Desktop software.
Click on the “Connect” button.

Go to “UPGRADE” -> "UPGRADE FIRMWARE" tab.

Click "AUTO UPGRADE"

Make sure the RF receiver (if available) is already removed.
Select Gimbal firmware version to upgrade

Click “Upgrade” button. The process will take about 2 minutes. When the firmware is upgraded successfully, click "DONE", the gimbal will be restarted automatically.

Option 2: Manual upgrade

Step 1: Before the upgrade

Download the latest Software version for MAC or Windows if not installed yet.
Unplug the Remote Receiver (SBUS, JR, …) if it was plugged into the gStabi system.
Power on the gimbal.
Connect Gimbal to your Mac or PC by USB cable.

Step 2: Upgrade firmware

Run the gTune Desktop software.
Click on the “Connect” button.

Go to “UPGRADE” -> "UPGRADE FIRMWARE" tab.

Click "MANUAL UPGRADE"

BROWSE” to firmware file from your computer.

Disconnect any RC or COM port that are being connect with gimbal before upgrading.
Click “Upgrade” button. The process will take about 2 minutes. When the firmware is upgraded successfully, click "DONE", the gimbal will be restarted automatically.