M600

GREMSY T7

Q 1: Does Gremsy T7 support M600 or A3 + Lightbridge 2 control?

• The T7 supports control through M600 or any drone frame using A3 FC and Lightbridge 2.

Q 2: Which kind of operator it supports?

• The T7 supports both single and dual operators (slave and master).

Q 3: How to configure Gremsy gimbal to use with DJI Lightbridge 2 or M600’s remote?

Step 1: Install the latest Software/Firmware The firmware and software were updated at Download. Step 2: Connect Gremsy gimbal to GPS of Flight controller A3/N3 Step 3: Select Single or Dual Mode At Single Mode, in software: Go to Setting -> Controls -> LightBridge 2 -> Single - Move the GIMBAL DIAL on the remote to turn on the motors. - Toggle C1 to control tilt or pan (make sure Tilt in TILT LOCK , go to SETTINGS -> FOLLOW-TILT->TILT LOCK). - Pan will be in follow mode if not use GIMBAL DIAL for PAN control. At Dual Mode, in software: Go to Setting -> Controls -> LightBridge 2 -> Dual - Move the GIMBAL DIAL on the remote to turn on the motors. - Use Tilt/roll/pan stick to control tilt/roll/pan.