DOWNLOAD
GREMSY H3
UPGRADE FIRMWARE INSTRUCTION
STEP 1: INSTALL USB DRIVER
Make sure you installed the Driver for USB before continuing the next steps.
STEP 2: UPGRADE FIRMWARE
1/ Before upgrade:
– Download the latest Software version for MAC or Windows if not install yet. – Install USB Driver if not installed yet. – Download the Firmware in Zip format. – Unzip to get the *.hex file. – Unplug Remote Receiver (SBUS, JR, …) if it was plugged to gStabi system. – Connect Gimbal to you Mac or PC by USB cable.
2/ During upgrade:
– Power on Gimbal. – Run the software and select Upgrade. – Follow Steps on the screen.
3/ Troubleshooting
If you have failed during the firmware upgrade, please follow this article to configure again You can also contact our support via [email protected] for prompt support
FIRMWARE
What's new?
Support Heated IMU
Support for H16 used relative encoder.
Lightbridge 2 control : + C1 button : on/off motor In Single mode + C2 button : change mode on dual operator ( only apply on master remote)
SOFTWARES
05 - 05 - 2023
APP
DOCUMENTS & MANUALS
Last updated