M600 (A3 + LIGHBRIDGE 2)
PIXY U
- Pixy U supports control through M600 or any drone frame using A3 FC and Lightbridge 2.
- Pixy U supports both single and dual operators (slave and master).
- Step 1: Install the lasted Software/Firmware
The firmware and software were updated at Download.
- Step 2: Connect Gremsy gimbal to GPS of Flight controller A3/N3
- Step 3: Select Single or Dual Mode
At Single Mode, in software:
- Go to Setting -> Controls -> LightBridge 2 -> Single
- Move GIMBAL DIAL on the remote to turn on the motors.
- Toggle C1 to control tilt or pan (make sure Tilt in TILT LOCK , go to SETTINGS -> FOLLOW-TILT->TILT LOCK).
- Pan will be in follow mode if not use GIMBAL DIAL for PAN control.
At Dual Mode, in software:

- Go to Setting -> Controls -> LightBridge 2 -> Dual
- Move GIMBAL DIAL on the remote to turn on the motors.
- Use Tilt/roll/pan stick to control tilt/roll/pan.

Last modified 1yr ago