DOWNLOAD
GREMSY S1V2
Last updated
GREMSY S1V2
Last updated
Make sure you installed the Driver for USB before continuing the next steps.
1/ Before upgrade:
– Download the latest Software version for MAC or Windows if not install yet. – Install USB Driver if not installed yet. – Download the Firmware in Zip format. – Unzip to get the *.hex file. – Unplug Remote Receiver (SBUS, JR, …) if it was plugged to gStabi system. – Connect Gimbal to you Mac or PC by USB cable.
2/ During upgrade:
– Power on Gimbal. – Run the software and select Upgrade. – Follow Steps on the screen.
3/ Troubleshooting
If you have failed during the firmware upgrade, please follow this article to configure again You can also contact our support via [email protected] for prompt support
What's new?
Support for S1 used relative encoder.
Improve find home performance
Lightbridge 2 control : + C1 button : on/off motor + C2 button : change mode in dual operator ( only apply on master remote)
What's new?
Support for T3V2 used absolute encoder.
Improve find home performance.
Lightbridge 2 control : + C1 button : on/off motor + C2 button : change mode in dual operator ( only apply on master remote)
05 - 05 - 2023
Gremsy S1 Firmware 5.6.3 03 - 01 - 2019
Gremsy S1V2 Firmware 7.6.0 05 - 05 - 2023
Windows: gTune Desktop v1.4.9.1 05 - 05 - 2023
Android : gTune - Version 2.2.8 14 - 06 - 2018
(iOS - iPhone/iPad) gTune - Version 2.2.8 14 - 06 - 2018
