UPGRADE GIMBAL FIRMWARE
The information about UPGRADE FIRMWARE for ZIO PAYLOADS and VIO PAYLOADS.
Last updated
The information about UPGRADE FIRMWARE for ZIO PAYLOADS and VIO PAYLOADS.
Last updated
Step 1: Before the upgrade
Download the latest Software version for MAC or Windows if not installed yet.
Unplug the Remote Receiver (SBUS, JR, …) if it was plugged into the gStabi system.
Power on the gimbal.
Connect Gimbal to your Mac or PC by USB cable.
Step 2: Upgrade firmware
Run the gTune Desktop software.
Click on the “Connect” button.
Go to “UPGRADE” -> "UPGRADE FIRMWARE" tab.
Click "AUTO UPGRADE"
Make sure the RF receiver (if available) is already removed.
Select Gimbal firmware version to upgrade
Click “Upgrade” button. The process will take about 2 minutes. When the firmware is upgraded successfully, click "DONE", the gimbal will be restarted automatically.
Step 1: Before the upgrade
Download the latest Software version for MAC or Windows if not installed yet.
Unplug the Remote Receiver (SBUS, JR, …) if it was plugged into the gStabi system.
Power on the gimbal.
Connect Gimbal to your Mac or PC by USB cable.
Step 2: Upgrade firmware
Run the gTune Desktop software.
Click on the “Connect” button.
Go to “UPGRADE” -> "UPGRADE FIRMWARE" tab.
Click "MANUAL UPGRADE"
BROWSE” to firmware file from your computer.
Disconnect any RC or COM port that are being connect with gimbal before upgrading.
Click “Upgrade” button. The process will take about 2 minutes. When the firmware is upgraded successfully, click "DONE", the gimbal will be restarted automatically.
