GREMSY PRODUCT SUPPORT

GREMSY
Payloads
GENERAL
- UPGRADE FIRMWARE & SOFTWARE
  - GIMBAL FIRMWARE
    7.7.3 Upgrade Note
    How to Autotune?
- QUICK RELEASE
Gremsy Damping
- Rubber Specification
- Damping Plate Specification
Tiny Gimbal
- G-HADRON
PIXY & MIO
SERIES GREMSY T & S
Heavy Gimbal
- AEVO
PE
- GREMSY T3PE
GREMSY H SERIES
OPTIONAL MODULE

Powered by GitBook

On this page

Step 1: Put the camera on the gimbal camera cage.
Step 2: Pass the slide camera locked screws through the hole of the gimbal and tighten the screw.
Step 3: Tighten the tripod screw.
Step 4: Connecting cables between the camera and gimbal

Camera Mounting

Pixy LR

PreviousGimbal Balance NextDamping Mounting

Last updated 5 months ago

Step 1: Put the camera on the gimbal camera cage.

Step 2: Pass the slide camera locked screws through the hole of the gimbal and tighten the screw.

Torque: 0.63Nm

Step 3: Tighten the tripod screw.

Torque: 1.75Nm

Step 4: Connecting cables between the camera and gimbal

Connect the Camera Power cable to the camera.
Connect the Camera Connect Hub to camera.
Make sure the cables are properly connected.
Make sure the hub presses the power cable as shown in the picture.