GREMSY PRODUCT SUPPORT

GREMSY
Payloads
GENERAL
- UPGRADE FIRMWARE & SOFTWARE
  - GIMBAL FIRMWARE
    7.7.3 Upgrade Note
    How to Autotune?
- QUICK RELEASE
Gremsy Damping
- Rubber Specification
- Damping Plate Specification
Tiny Gimbal
- G-HADRON
PIXY & MIO
SERIES GREMSY T & S
Heavy Gimbal
- AEVO
PE
- GREMSY T3PE
GREMSY H SERIES
OPTIONAL MODULE

Powered by GitBook

On this page

PIXY & MIO

MIO TWO-AXIS

Getting Started

I/O Connection

PreviousDimension NextHardware Setup

Last updated 1 year ago

I. Mio Two-Axis Sub Board I/O Connection:

1. Power IN:

Voltage input range from 15-52V. Connector Type: XT30UPB-M.

2. USB Type-C: Use for debugging and configure.

3. SBUS, PPM Control:

Connector Type: Dupont 3pin 2.54mm.

4. COM2:

Connector Type: BM06B-GHS-TBT(LF)(SN).

Pin number

1

5V

2

UART2_TXD

3

UART2_RXD

4

NC

5

NC

6

GND

*Pin order is from the left to the right.

5. Auxiliary Connector:

Pin number

1

S1

2

S2

3

S3

4

S4

5

S5

6

S6

7

GND

8

12V

*Pin order is from the left to the right.

6. Micro HDMI

7. Power OUT

II. Mio Two-Axis Tilt Board I/O Connection:

1. Auxiliary Connector

Connector Type: BM08B-GHS-TBT(LF)(SN)

Pin number

1

S1

2

S2

3

S3

4

S4

5

S5

6

S6

7

GND

8

12V

*Pin order is from the left to the right.

2. Micro HDMI

Connector Type: BM08B-GHS-TBT(LF)(SN)

Voltage output: 12V Connector Type: XT30PW-F