# REMOTE CONTROL

T3 supports SBUS , SPEKTRUM and PPM receivers. There are some parameters to be aware of before assigning channels to the receiver. 

**SMOOTH:** increasing this number will smooth out the movement of the corresponding axis but will also cause a delay.
\
**SPEED MODE:** when speed mode is selected, the speed of the corresponding axis will depend on how
\
far the stick position is from the neutral position. It is recommended that TILT and PAN channels should be set to speed mode.
\
**ANGLE MODE:** when angle mode is selected, the corresponding axis will move to the angle set by the current stick/knob position. It’s recommended the ROLL channel should be set to angle mode.