SBUS/PPM SETTINGS

Connect SBUS/PPM receiver to the Hyper Quick release as shown below

The receiver must be connected to the correct wires. The SBUS/PPM port has 5V output to power the receiver; please do not use an external power supply to power the receiver at the same time. Doing so may damage the electronics inside the gimbal.

CHANNEL SETTING

Channel Overview

The gimbal supports 6 control channels:

  1. MODE

  2. TILT

  3. ROLL

  4. PAN

  5. TILT SPEED

  6. PAN SPEED

⚠️ Important: Always assign the MODE channel first, as it determines the gimbal's operating state.

MODE Channel Configuration

The MODE channel controls the gimbal's working state and should be assigned to a 3-position switch.

Switch Positions & Functions:

Switch Position

Mode

Motor Status

High

FOLLOW MODE

Motors ON

Middle

LOCK MODE

Motors ON

Low

Motors OFF

  • FOLLOW MODE: The gimbal follows the movement of the aircraft/operator.

  • LOCK MODE: Gimbal maintains fixed orientation regardless of movement.

  • MOTORS OFF: Gimbal motors powered down.

TILT, ROLL, and PAN Channel Configuration

The TILT and PAN channels should be in speed mode, and the ROLL channel in angle mode.

TILT SPEED or PAN SPEED could be assigned to the same channel and should be assigned to the throttle stick, dial, or other non-centering control on the transmitter.

Below is an example of channel assignment to the Futaba T8FG.

CHANNEL
CONTROL
NOTE

MODE

5

SC

3-Position Switch

TILT

2

J2

Speed Mode

ROLL

4

T4

Angle Mode

PAN

1

J1

Angle Mode

TILT SPEED

3

J3

PAN SPEED

6

RD

Last updated

Was this helpful?