M600
Configure Gremsy gimbal to use with DJI Lightbridge 2 or M600’s remote
1
Install the latest Software/Firmware
2
Connect Gremsy gimbal to GPS of Flight controller A3/N3
3
Select Single or Dual Mode
At Single Mode, in software:
Go to Setting -> Controls -> LightBridge 2 -> Single
- Move the GIMBAL DIAL on the remote to turn on the motors.
- Toggle C1 to control tilt or pan
(make sure Tilt in TILT LOCK , go to SETTINGS -> FOLLOW-TILT->TILT LOCK).
- Pan will be in follow mode if not use GIMBAL DIAL for PAN control.
At Dual Mode, in software:
Go to Setting -> Controls -> LightBridge 2 -> Dual
- Move the GIMBAL DIAL on the remote to turn on the motors.
- Use Tilt/roll/pan stick to control tilt/roll/pan.
Last updated
Was this helpful?