OPERATION MODE

LOCK MODE: is a stabilization mode where the camera maintains orientation. independently of the rest of the gimbal, and the orientation can be changed by an external control signal from remote control.

FOLLOW MODE: in this mode, the camera will mimic the operator’s movement. and allows one person to control camera tilt and pan without using an external device like a remote control.

SINGLE OPERATOR: using FOLLOW mode. DUAL OPERATOR: a second operator can use a Remote Controller (SBUS, SPEKTRUM, PPM) to control the gimbal’s movement.

WORKING OPERATION

Gremsy T3 has 2 working operations: normal and inverted.

After powering up the gimbal, it will automatically detect if the gimbal is in inverted operation or normal operation based on the pan motor position.

During working, switching to another working operation made easy by changing pan motor position, the gimbal will automatically detect new TIPS types of working operation.

SWITCHING BETWEEN MODES

Using function button

Press Times

Modes

Once time

Turn motors ON

2 times

Lock mode

3 times

Follow mode

Hold 3 seconds

Turn motors OFF

Using mode channel on remote control

Positions

Modes

High

Follow mode, Motors ON

Middle

Lock mode, Motors ON

Low

Motors OFF

Using GTUNE

If there is a remote control signal, changing modes or turning motors on/off by other methods such as using the function button or software will not take effect because the remote control signal has the highest priority and override the command.

Last updated

Was this helpful?