DOWNLOAD

GREMSY H7

UPGRADE FIRMWARE INSTRUCTION

STEP 1: INSTALL USB DRIVER

Make sure you installed the Driver for USB before continuing the next steps.
WINDOWS
WINDOWS
MAC OS

STEP 2: UPGRADE FIRMWARE

1/ Before upgrade:
– Download the latest Software version for MAC or Windows if not install yet. – Install USB Driver if not installed yet. – Download the Firmware in Zip format. – Unzip to get the *.hex file. – Unplug Remote Receiver (SBUS, JR, …) if it was plugged to gStabi system. – Connect Gimbal to you Mac or PC by USB cable.
2/ During upgrade:
– Power on Gimbal. – Run the software and select Upgrade. – Follow Steps on the screen.
3/ Troubleshooting
If you have failed during the firmware upgrade, please follow this article to configure again You can also contact our support via [email protected] for prompt support

FIRMWARE

Gremsy H16 firmware 4.4.1 26 - 07 - 2017
What's new?
  • Support Heated IMU
  • Support for H16 used relative encoder.
  • Lightbridge 2 control : + C1 button : on/off motor In Single mode + C2 button : change mode on dual operator ( only apply on master remote)
Gremsy H16 V2 Firmware 03 - 01 - 2019
What's new?
  • Support Heated IMU
  • Support for H16 used relative encoder.
  • Lightbridge 2 control : + C1 button : on/off motor In Single mode + C2 button : change mode on dual operator ( only apply on master remote)

SOFTWARES

APP

Android : gTune - Version 2.2.8 14 - 06 - 2018

DOCUMENTS & MANUALS