SBUS/PPM Receiver Connection

RECEIVER CONNECTION

Connect RC receiver to the right port on the Quick Release

Warning: The receiver must be connected to the correct wires. The SBUS/PPM port has a 5V output to power the receiver; please do not use the external power supply to power the receiver at the same time. Doing so may damage the electronics inside the gimbal.

Receiver Connection

Connect the SBUS/PPM receiver to the SBUS/PPM port on the Hyper Quick Release as shown in the picture.

The receiver must be connected to the correct wires in order. The SBUS/PPM port has a 5V output to power the receiver; please do not use an external power supply to power the receiver at the same time. Doing so may damage the electronics inside the gimbal.

There are 6 channels to assign: MODE, TILT, ROLL, PAN, TILT SPEED, PAN SPEED.

Assign the MODE channel first, then follow the order above because the MODE channel is used to change operating modes of the gimbal and should be assigned to a 3-position switch as follows:

• Switch at high position: FOLLOW MODE , MOTORS ON

• Switch at middle position: LOCK MODE , MOTORS ON

• Switch at low position: MOTORS OFF

Channel Setting

The TILT and PAN channels should be in speed mode and the ROLL channel in angle mode.

TILT SPEED or PAN SPEED could be assigned to the same channel and should be assigned to a throttle stick, dial, or other non-centering control on the transmitter.